Qingdao Antai Import and Export Co.,Ltd

Qingdao Antai Import and Export Co.,Ltd

Pressure Casting

Pressure Casting


Pressure casting, also known in manufacturing industry as low pressure casting or pressure pouring, is another variation of permanent mold casting. Instead of pouring the molten metal into the casting and allowing gravity to be the force that distributes the liquid material through the mold, pressure casting uses air pressure to force the metal through the gating system and the metal casting's cavity. This process can be used to cast high quality manufactured parts. Often steel castings are cast in graphite molds using this process. For example, in industry, steel railroad car wheels are cast with this method.

The Process

This is a permanent mold process and the manufacture of the mold in pressure casting is standard in most regards, see basic permanent mold casting. Two blocks are machined extremely accurately, so they can open and close precisely for removal of metal parts. The casting's gating system is machined into the mold. The gating system is set up so that the molten material flows into the mold from the bottom instead of the top, (like in gravity fed processes).

The mold is set up above the supply of liquid metal to be used for the casting. A refractory tube goes from the entrance of the gating system down into the molten material.


Casting Operation Is Ready To Begin

During manufacture by this process, the chamber that the liquid material is in is kept air tight. When the mold is prepared and ready for the pouring of the metal casting, air pressure is applied to the chamber. This creates pressure on the surface of the liquid, that in turn forces molten material up the refractory tube and throughout the mold.


On Surface Of Molten Material

Pressure used in pressure casting is usually low, 15lbs/in2 could be typical for industrial manufacture using this process.


Material Forced Up Refractory Tube

The air pressure is maintained until the metal casting has hardened within the mold. Once the cast part has solidified, the mold is opened and the part is removed.


Applied During Solidification

Properties And Considerations Of Manufacturing By Pressure Casting

  • Pressure casting manufacture can be used to produce metal castings with superior mechanical properties, good surface finish, and close dimensional accuracy. 

  • Like in other permanent mold methods, the mold needs to be able to open and close for removal of the work piece. Therefore, very complicated casting geometry is limited. 

  • Since the refractory tube is submersed in the molten material, the metal drawn for the casting comes from well below the surface. This metal has had less exposure to the environment than the material at the top. Gas trapped in the metal as well as oxidation effects are greatly reduced. 

  • The high setup cost makes pressure casting not efficient for small runs, but an excellent productivity rate makes it suitable for large batch manufacture. 

Copyright © Qingdao Antai Import and Export Co.,Ltd. All Rights Reserved.
QR Code